Trv19 user manual

It is best to use only unleaded solder but unleaded solder may also be added to ordinary solder. After correcting the original service problem, perform the following.

Replace only with the same or equivalent type. Page of 24 Go. Schematics , wiring and block diagrams. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: — Reorient or relocate the receiving antenna. The supplied interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.

Video recording system 2 rotary heads Helical scanning system Audio recording system Rotary heads, PCM system Quantization: 12 bits Fs 32 kHz, stereo 1, stereo 2 , 16 bits. Fs 48 kHz, stereo Video signal. When converted to a 35 mm still camera. Output impedance with less than 2. MIC jack Minijack, 0. Picture 6. Total dot number Power requirements 7. During camera recording using LCD. Operating temperature 0.

Storage temperature — Dimensions approx. Mass approx. Main unit only. Page Adjusting The Exposure Adjusting the exposure When to adjust the exposure Adjust the exposure manually under the following cases.

Page Superimposing A Title Superimposing a title If you use a tape with cassette memory, you can superimpose the titles while recording or after recording. When you play back the tape, the title is displayed for 5 seconds from the point where you superimposed it. Page Making A Custom Title Making a custom title If you use a tape with cassette memory, you can make one title of up to 20 characters and store it in memory.

The last character is erased. Erase characters one after another, then make the new title again. Page Labeling A Cassette Labeling a cassette If you use a tape with cassette memory, you can label a cassette. The label can consist of up to 10 characters and is stored in cassette memory.

When you insert the labeled cassette and turn the power on, the label is displayed on the LCD screen, in the viewfinder, or on the TV screen. To change the label you have made Insert the cassette to change the label, and operate in the same way to make a new label.

If the mark appears in step 4 The cassette memory is full. You can release the SteadyShot function when you do not need to use the SteadyShot function. Do not use the SteadyShot function when shooting a stationary object with a tripod. If you connect the white plug, the sound is L left signal. If you connect the red plug, the sound is R right signal.

The camcorder may not search if the beginning of the recorded date is too close to the next one. Playback starts automatically when date changed. Playback starts from the photo automatically. Page Editing Onto Another Tape And when you playback the picture using the other video equipment, the picture may jitter. Page Starting Editing 1 Insert a blank tape or a tape you want to record over into the VCR, and insert your recorded tape into the camcorder.

Then press P to set it to playback pause mode. Page Audio Dubbing Audio dubbing You can record an audio sound to add to the original sound on a tape by connecting audio equipment or a microphone. If you connect the audio equipment, you can add a sound on your recorded tape by specifying starting and ending points.

The original sound will not be erased. Page Additional Information We recommend you to use the tape with cassette memory. The IC memory is mounted on this type of mini DV cassette.

This camcorder can read and write data such as dates of recording or titles, etc. The functions using the cassette memory require successive signals recorded on the tape. Even if the vanadium-lithium battery is not charged, it will not affect the camcorder operation. To retain the date and time, etc. Set the time according to the local time in your country.